Hyper Air Cooler

Product Guide:

1.  Please connect the USB cable to 2A adapter / power bank / 2A USB port.
2.  Output Voltage: 5V.

Installation:

1.  Pull out the filter drawer and remove the filter. Soak the filter in cold water, and then put it back in place. Not required: The filter can be frozen in the refrigerator after soaking, the effect will be better: supply cooling air 8-15°).
2.  Fill the water tank of NexFan directly.
3.  Plug in the USB cable to power on and start using.

Usage:

1.  The master button can control power and fan: click the button to switch between high, medium and low wind speed and fog off, press and hold for 1.5 seconds to shut down.
2.  The auxiliary button can control spray, UV-C and light, short press to switch light color (available in seven colors and gradients), double-click to control spray & UV-C on or off.

Maintenance:

Recommendation: Clean your air cooler once a week; replace the filter every 3~6 months.

1.  Use up the water in the water tank or carefully drain it before cleaning.
2.  If the water tank is dirty, use a small brush (such as a toothbrush, bottle brush, etc.) to clean it carefully, and then rinse it with water.
3.  Pull out the filter tray, take out the filter and remove the filter element. Wash them with warm soapy water and dry them.

Warnings:

• Don’t move Newfan filled with water to avoid overflow.
• Only use clean water. Use distilled water if necessary.
• Although NewFan has a sterilizing function, large dust/dirt particles may reduce the lifetime of the unit.
• Unplug NewFan when cleaning, removing/replacing the filter, or moving the device.
• We recommend using it only in dry locations. If it is used in a humid environment, be careful not to splash Water on the surface of the unit.
• If the surface of the device leaks or overflows, unplug it and let it dry for 24 hours, then you can use it normally.
• Do not store water when not in use for a long time. Do not touch the USB cable with wet hands. Do not put other things in/on the NewFan.
• Do not block the front and back grills of the device.
• No inverting.
• No soak/shower.
• No smashing.

Tips:

• Please move it horizontally.
• Please put it in a position that is not easy to fall off.
• Keep the NewFan away from the heater or electrical equipment; Please use the equipped USB cable.
• The filter replacement was designed especially for the NewFan. If it has been broken, please purchase the filter replacement.
• The child and the elderly are required to use it under the guidance of their guardians.
• After starting up, the spray and UV-C functions run at maximum power for 30 minutes, and after 30 minutes they are switched to the energy-saving mode. The spray and UV-C will stop after 2 hours, but it can be restarted manually.
• The manufacturer does not bear any responsibility for any damage from failure to comply with this product guide.